UMN:CLI User Manual
V5808
284
To configure the operation mode of the member port, use the following command.
lacp port activity PORTS {active
| passive}
Configures the operation mode of the member port.
(default: active)
To delete the configured operation mode of the member port, use the following command.
no lacp port activity PORTS
Deletes the configured operation mode of the member
port.
8.2.2.4 Priority of Switch
In case the member ports of connected switches are configured as Active mode (LACP
system enabled), it is required to configure which switch would be a standard for it. For
this case, the user could configure the priority on switch. The following is the command of
configuring the priority of the switch in LACP function.
lacp system priority <1-65535>
Sets the priority of the switch in LACP function, enter
the switch system priority. (default: 32768)
To delete the priority of configured switch, use the following command.
Clears the priority of the configured switch.
8.2.2.5 Manual Aggregation
The port configured as member port is basically configured to aggregate to LACP.
However, even though the configuration as member port is not released, they could
operate as independent port without being aggregated to LACP. These independent ports
cannot be configured as trunk port because they are independent from being aggregated
to LACP under the condition of being configured as member port.
To configure member port to aggregate to LACP, use the following command.
lacp port aggregation PORTS
{aggregatable | individual}
Configures the property of a specified member port for
LACP. (default: aggregatable)
To clear aggregated to LACP of configured member port, use the following command.
no lacp port aggregation PORTS
Deletes the configured property of a specified member
port for LACP.
To Next Page
Loading...