User Manual UMN:CLI
V5808
385
8.8 Rate Limit
User can customize port bandwidth according to user’s environment. By this configuration,
you can prevent a certain port to monopolize whole bandwidth so that all ports can use
bandwidth equally. Egress and ingress can be configured both to be same and to be
different.
The V5808 can apply the rate limit with 64 Kbps unit for GE port, and support ingress
policing and egress shaping.
To set a rate limit for ports, use the following command.
rate-limit port PORTS rate RATE
{egress | ingress dot3x}
Sets a rate limit for ports. If you input egress or ingress,
you can configure outgoing packet or incoming packet.
The unit is 64 Kbps.
no rate-limit port PORTS {egress
| ingress dot3x}
Clears a specified rate limit for port.
For the ingress rate limit, the flow control should be enabled on a specified port! For more
information of the flow control, see Section 5.1.5.
To display a configured rate limit, use the following command.
Shows a configured rate limit.
To Next Page
Loading...