Dasan V5808 - OLT Bit Error Ratio (BER)

UMN:CLI User Manual
V5808
640
disable}
function.
To configure ONU deactivation monitoring, use the following command.
Command
Mode
Description
olt deactive-monitor alarm-raise
<1-99>
GPON-OLT
Sets the deactive ONU-raise percent.
1-99: (default: 30%)
olt deactive-monitor alarm-
clear<1-99>
Sets the deactive ONU-clear percent. If the current
percent becomes higher than this value, the alarm
status changes to off.
1-99: (default: 70%)
olt deactive-monitor period <10-
86400>
Sets the deactive ONU monitoring period. If the current
percent is higher than a alarm-raise percent, the alarm
is off and the current percent changes to 100% after a
period.
10-86400: deactive ONU monitoring period (default: 10
seconds)
no olt deactive-monitor alarm-
raise
Deletes the configured value of deactive ONU
monitoring parameters.
no olt deactive-monitor alarm-
clear
no olt deactive-monitor period
To display the configuration of ONU deactivation monitoring, use the following command.
Command
Mode
Description
show olt deactive-monitor [OLT-
ID]
Enable
Global
GPON
Shows the configuration of ONU deactivation
monitoring.
show olt deactive-monitor
GPON-OLT
To clear the alarms of ONU deactivation monitoring, use the following command.
Command
Mode
Description
clear olt deactive-monitor alarm
GPON-OLT
Clears the collected alarms by ONU deactivation
monitoring.
12.1.17 OLT Bit Error Ratio (BER)
You can configure the monitor direction and the alarm threshold of the bit error ratio. The
system generates a bit error ratio (BER) alarm when the total number of error bits or bit
error rate of the data transferred between the OLT and ONUs exceeds the alarm
threshold. Both uplink and downlink data between OLT and ONU can be monitored.
To configure the OLT Bit Error Ratio (BER), use the following command.
Command
Mode
Description