UMN:CLI User Manual
V5808
564
The following example shows how to configure the distance with more than 2 options:
• distance ospf external <1-255> inter-area <1-255>
• distance ospf inter-area <1-255> intra-area <1-255>
To make it as a default, use the following command.
Restores it as the default.
Deletes a configured distance of OSPF route.
11.2.15 Host Route
OSPF regards routing information of specific host as stub link information. Routing
information can be assigned to each host which is connected with one router.
To configure the routing information to each host, use the following command.
host A.B.C.D area {A.B.C.D | <1-4294967295>}
Configures the routing information to
each host.
host A.B.C.D area {A.B.C.D | <1-4294967295>}
cost <0-65535>
To delete the routing information of specific host, use the following command.
no host A.B.C.D area { A.B.C.D | <1-
4294967295>}
Deletes the routing information to each
host.
no host A.B.C.D area { A.B.C.D | <1-
4294967295>} cost <0-65535>
11.2.16 Passive Interface
The passive interface which is configured by OSPF network operate as stub area.
Therefore passive interface can not exchange the OSPF routing information. To configure
the passive interface, use the following command.
passive-interface INTERFACE
[A.B.C.D]
Configures the passive interface.
To release the configured as passive interface, use the following command.
no passive-interface INTERFACE
[A.B.C.D]
Releases the configured as passive interface.
To Next Page
Loading...