Dasan V5808 - Displaying Ospfv3 Information

User Manual UMN:CLI
V5808
585
Command
Mode
Description
summary-address X:X::X:X/M
Router
Creates the aggregate addresses for OSPFv3.
summary-address X:X::X:X/M
not-advertise
Blocks routes that match the specified prefix/length
pair.
summary-address X:X::X:X/M
tag <0-4294967295>
Configures the summary routing information with a
specific tag
To delete the specified aggregate addresses for the OSPFv3, use the following command.
Command
Mode
Description
no summary-address X:X::X:X/M
Router
Deletes the specified aggregate addresses
no summary-address X:X::X:X/M
{not-advertise | tag <0-
4294967295>}
11.3.13 Finding Period
OSFP start to find the shortest path as soon as got a notification of changing the network
component. You can configure the period to find the path. To configure the period of
finding, use the following command.
Command
Mode
Description
timers spf SPF-DELAY SPF-
HOLD
Router
Configures the period of finding in the unit of second.
SPF-DELAY: 0-2147483647
SPF-HOLD: 0-2147483647
To release the configuration, use the following command.
Command
Mode
Description
no timers spf
Router
Release the configuration.
11.3.14 OSPFv3 Monitoring and Management
You can view all kinds of statistics and database recorded in IP routing table. This
information can be used to enhance system utility and solve problem in case of trouble.
You can check network connection and data routes through the transmission.
11.3.14.1 Displaying OSPFv3 Information
To display the information about OSPFv3 protocol, use the following command.
Command
Mode
Description
show ipv6 ospf
Enable
Shows the information about OSPFv3 protocol.