UMN:CLI User Manual
V5808
586
Shows the information about a specific process ID in
OSPFv3 protocol.
To display the OSPFv3 database, use the following command.
show ipv6 ospf [WORD] database
Shows the OSPFv3 database.
show ipv6 ospf [WORD] database {external |
network | router | inter-router | inter-prefix | link |
nssa-external | intra-prefix | grace} [self-originate
| adv-router A.B.C.D]
show ipv6 ospf database {self-originate | max-
age | adv-router A.B.C.D}
To display the interface information of OSPFv3, use the following command.
show ipv6 ospf interface [INTERFACE]
Shows the interface information of
OSPFv3
To display the information of neighbor route, use the following command.
show ipv6 ospf [WORD] neighbor
Shows the information of neighbor
router.
show ipv6 ospf [WORD] neighbor A.B.C.D
show ipv6 ospf [WORD] neighbor INTERFACE
[detail]
show ipv6 ospf [WORD] neighbor detail
To display OSPFv3 paths to OSPF routers, use the following command.
show ipv6 ospf [WORD] topology
Shows the OSPFv3 paths to OSPF
routers.
show ipv6 ospf [WORD] topology area {<0-
4294967295 | A.B.C.D}
To display the routing information which is registered in routing table, use the following
command.
show ipv6 ospf [WORD] route
Shows the routing information which is registered in
routing table.
To Next Page
Loading...