Dasan V5808 - Interface Configuration Mode; Main Command of DHCP Option 82 Configuration Mode; IP Tunnel Configuration Mode; Main Command of Interface Configuration Mode

UMN:CLI User Manual
V5808
44
To open DHCP Option 82 Configuration mode, enter the ip dhcp option82 command,
then the system prompt will be changed from SWITCH(config)# to SWITCH(config-
opt82)#.
Command
Mode
Description
ip dhcp option82
Global
Opens DHCP Option 82 Configuration mode to
configure DHCP option 82.
To open DHCP Option 82 Configuration mode, use the service dhcp command in the
Global Configuration mode first!
Tab. 3.7 is the main commands of DHCP Option 82 Configuration mode.
Command
Description
policy
Configures the policy for option 82 field in the DHCP packet.
system-remote-id
Configures a system remote ID.
system-circuit-id
Configures a system circuit ID.
Tab. 3.7 Main Command of DHCP Option 82 Configuration Mode
3.1.8 Interface Configuration Mode
In Interface Configuration mode, you can configure Ethernet interfaces. GPON interfaces
should be configured in GPON-OLT Configuration mode.
To open Interface Configuration mode, enter the interface command, then the system
prompt will be changed from SWITCH(config)# to SWITCH(config-if)#.
Command
Mode
Description
interface INTERFACE
Global
Opens Interface Configuration mode.
Tab. 3.8 shows main commands of Interface Configuration mode.
Command
Description
description
Specifies a description.
ip address
Assigns IP address.
shutdown
Deactivates an interface.
mtu
Sets MTU value.
Tab. 3.8 Main Command of Interface Configuration Mode
3.1.9 IP Tunnel Configuration Mode
You can create a tunnel interface and then configure this logical interface for your IP
tunnel.
To open Interface tunnel mode, enter the interface tunnel command, then the system
prompt will be changed from SWITCH(config)# to SWITCH(config-if[tunnel])#.
!