Dasan V5808 - MST Region

UMN:CLI User Manual
V5808
304
8.3.6.1 MST Region
To set the configuration ID of MST region in detail, you need to open MSTP Configuration
mode first. To open MSTP Configuration mode, use the following command.
Command
Mode
Description
spanning-tree mst configuration
Bridge
Opens MSTP Configuration mode.
After opening MSTP Configuration mode, the prompt changes from SWITCH(bridge)# to
SWITCH(config-mst)#.
To delete all configations from MSTP Configuration mode, use the following command.
Command
Mode
Description
no spanning-tree mst
configuration
Bridge
Deletes all configurations on MSTP Configuration
mode, returns to the default values.
If MSTP is established in the V5808, decide a MSTP region the switch is going to belong
to by configuring the MST configuration ID. Configuration ID contains a region name,
revision, and a VLAN map.
To set the configuration ID, use the following command on MSTP Configuration mode.
Command
Mode
Description
name NAME
MST-config
Sets the MSTP region name:
NAME: the name of MSTP region.
instance <1-64> vlan VLANS
Maps the specified vlans to an MSTP instance:
1-64: select an instance ID number.
VLANS: VLAN ID (1-4094)
revision <0-65535>
Specifies a revision number:
0-65535: the MSTP configuration revision number.
In case of configuring STP and RSTP, you do not need to set the configuration ID. If you
try to set configuration ID on STP or RSTP, an error message will be displayed.
You can create the MSTP regions without limit on the network. But the instance id
numbers of each region should not be over 64.
i
i