UMN:CLI User Manual
V5808
170
syslog output priority {auth | authpriv |
kern | local0 | local1 | local2 | local3 |
local4 | local5 | local6 | local7 | syslog |
user} {emerg | alert | crit | err | warning |
notice | info} local {volatile | non-
volatile}
Generates a user-defined syslog message
with a priority in the system memory.
volatile: deletes a syslog message after
restart.
non-volatile: reserves a syslog message.
syslog output priority {auth | authpriv |
kern | local0 | local1 | local2 | local3 |
local4 | local5 | local6 | local7 | syslog |
user} {emerg | alert | crit | err | warning |
notice | info} remote {A.B.C.D | X:X::X:X}
[vrf VRFNAME]
Generates a user-defined syslog message
with a priority and forwards it to a remote
host.
To disable a user-defined syslog output level, use the following command.
no syslog output priority {auth |
authpriv | kern | local0 | local1 | local2 |
local3 | local4 | local5 | local6 | local7 |
syslog | user} {emerg | alert | crit | err |
warning | notice | info} console
Deletes a specified user-defined syslog
output level with a priority.
no syslog output priority {auth |
authpriv | kern | local0 | local1 | local2 |
local3 | local4 | local5 | local6 | local7 |
syslog | user} {emerg | alert | crit | err |
warning | notice | info} local {volatile |
non-volatile}
no syslog output priority {auth |
authpriv | kern | local0 | local1 | local2 |
local3 | local4 | local5 | local6 | local7 |
syslog | user} {emerg | alert | crit | err |
warning | notice | info} remote {A.B.C.D |
X:X::X:X}
Syslog Index Level with a Priority
To set a user-defined syslog message index level with a priority, use the following
command.
syslog index {system | physical-
entity | dhcp | filter | gpon | loop-
detect | snmp} INDEX priority
{emerg | alert | crit | err | warning
| notice | info | debug}
Generates a user-defined syslog message index with a
priority
no syslog index {system |
Deletes a specified user-defined syslog nessage index
To Next Page
Loading...