Dasan V5808 - DS1 Mode; Line Type; TDM Service Configuration

User Manual UMN:CLI
V5808
735
12.4.7.5 DS1 Mode
To specify the mode of DS1, use the following command.
Command
Mode
Description
ds1-mode connect ds1-cpe line-
length { short | long }
Traffic-CES
Specifies the mode of DS1.
ds1-cpe: DS1 CPE (loopback: smart jack)
ds1-niu-cpe: DS1 NIU CPE (loopback: intelligent office
repeater)
short: line length - short haul
long: line length - long haul
no-power: no power feed
with-power: with power feed
ds1-mode connect ds1-niu-cpe
power { no-power | with-power }
no ds1-mode
Deletes the configured DS1 mode.
12.4.7.6 Line Type
To specify the line type used in DS3 or E3 application, use the following command.
Command
Mode
Description
line-type { other | ds3-m23 | ds3-
syntran | ds3-cbit-parity | ds3-
clear-channel | e3-framed | e3-
plcp }
Traffic-CES
Specifies the line type used in a DS3 or E3 application.
(mandatory for DS3 and E3 interfaces, not applicable
to other interfaces)
12.4.7.7 TDM Service Configuration
In order to configure TDM service, you need to create an TDM service ID. To create the
TDM service ID and enter the configuration mode for the service, use the following
command.
Command
Mode
Description
tdm-service SERVICE_ID mode
{ pw-ip | pw-mef8 | pw-mpls }
Traffic-CES
Creates a TDM service ID and enters the configuration
mode for the service.
pw-ip: pseudowire IP transport (UDP/IP)
pw-mef8: pseudowire MEF8
pw-mpls: pseudowire MPLS
no tdm-service SERVICE_ID
Deletes the created TDM service ID.
After creating a TDM service ID with pw-ip option, the prompt changes from
SWITCH(config-traffic-pf[NAME]-ces[PORT])# to SWITCH(config-traffic-pf[NAME]-
ces[PORT]-svc[ID]-pw-ip)#. In this mode, you can perform the following configuration.