Dasan V5808 - MAC Learning; Port Bridge; Multicast Interworking Termination Point; ANI Port Configuration

User Manual UMN:CLI
V5808
717
12.4.3.1 Max Host
To configure the max host for a MAC bridge service profile, use the following command.
Command
Mode
Description
max-hosts <0-255>
Traffic-
Bridge
Traffic
Bridge-UNI
Sets the maximum number of hosts.
0-255: maximum MAC number (0: unlimited)
no max-hosts
Deletes the configured max host.
12.4.3.2 MAC Learning
To enable/disable the ONU’s MAC learning, use the following command.
Command
Mode
Description
mac-learning {enable | disable}
Traffic-
Bridge
Enables/disables the MAC learning for this bridge
service profile. (default: enable)
12.4.3.3 Port Bridge
The L2 port bridge feature allows the port to forward the packets that the outgoing
interface in the MAC address entry is the same as the incoming interface where the
packet arrived. To enable/disable the L2 port bridge feature, use the following command.
Command
Mode
Description
port-bridge enable
Traffic-
Bridge
Enables L2 port bridge feature.
port-bridge disable
Disables L2 port bridge feature.
12.4.3.4 Multicast Interworking Termination Point
The multicast GEM port is represented by a GEM network Connection Termination Point
Managed Entity (CTP ME) and a multicast GEM interworking TP ME. The multicast GEM
interworking TP is then connected into the ONU through a MAC Bridge Config Data ME.
To enable/disable the MAC bridge port configuration of MAC bridge service profile for
multicast Interworking Termination Point (IW TP), use the following command.
Command
Mode
Description
multicast link-mac-bridge
enable
Traffic-
Bridge
Connects the multicast GEM port network CTP ME to a
MAC bridge service profile ME. (default)
multicast link-mac-bridge
disable
Disables the connections between the multicast GEM
port network CTP ME to the MAC bridge service
profile.
12.4.3.5 ANI Port Configuration
To enable/disable a connection between MAC bridge service profile and a mapper ID, use
the following command.