UMN:CLI User Manual
V5808
718
Connects a MAC bridge service profile with a mapper
ID.
MAPPER_ID: 1 to 32, IEEE802.1p mapper ID
Disconnects a mapper ID from the MAC bridge service
profile.
To enable/disable a connection between MAC bridge service profile and the GEM Port ID
Network TCP, use the following command.
Connects a MAC bridge service profile with a GEM
Port ID.
GEM_NUM: GEM port ID (1 to 32)
Disconnects a GEM Port ID from the MAC bridge
service profile.
If there are more than one mapper connected to a MAC bridge service profile, you need
to configure a VLAN tagging filtering for VLAN ID-based traffic forwarding. To
enable/disable VLAN tagging filtering function on ANI interface, use the following
command.
vlan-filter [vid <1-4094>]
untagged {allow | discard}
Enables a VLAN tagging filtering function of ANI-side
port.
allow: forwards the untagged frames to the ANI-side
port
discard: blocks the untagged frames to the ANI-side
port
1-4094: VLAN ID(s)
vlan-filter vid {add | del} VID
Adds or deletes the VLAN ID on the VLAN list
configured by vlan-filter vid command above.
Disables the VLAN tagging filtering function.
The provides an alternate approach to address filtering from that supported through
MAC bridge port filter table data. This alternate approach is useful when all groups of
addresses are stored beforehand in the ONU, and it designates which groups are valid or
invalid for filtering. On a circuit pack in which all groups of addresses are pre-assigned
and stored locally, the ONU creates or deletes an instance of this managed entity
automatically upon creation or deletion of a MAC bridge port configuration data ME.
To enable/disable MAC filtering function on ANI interface, use the following command.
To Next Page