Dasan V5808 - Voip MGC Configuration; Message ID Configuration

User Manual UMN:CLI
V5808
659
have access to the softswitch.
To configure the authentication user name and password for VoIP user to have access to
softswitch, use the following command.
Command
Mode
Description
onu voip-sip ONU-ID auth pots
POTS-NUM NAME [PASSWD]
GPON-OLT
Configures an user ID and password for a specified
VoIP device connected to an ONU to have access to
softswitch.
ONU-ID: 1-128 or ONU serial number
POTS-NUM: POTS port number
NAME: user name used for authentication
PASSWD: password used for authentication
no onu voip-sip ONU-ID auth
pots POTS-NUM
Deletes the configured authentication information for
VoIP user.
The user display name, phone number, authentication user name and password is limited
to a maximum of 25 characters (bytes).
To display VoIP service and VoIP line status information, use the following command.
Command
Mode
Description
show onu voip line OLT-ID ONU-
ID
Enable
Global
GPON
Shows the information of VoIP service and line status.
ONU-ID: 1-128 or ONU serial number
show onu voip line ONU-ID
GPON-OLT
12.2.10 VoIP MGC Configuration
12.2.10.1 Message ID Configuration
To configure the message ID according to the specific VoIP service, use the following
command.
Command
Mode
Description
onu voip-mgc ONU-ID message-
id service VOIP_SERVICE
MESSAGE_ID
GPON-OLT
Configures the message ID according to the specific
VoIP service.
ONU-ID: ONU ID or serial number
VOIP_SERVICE: VoIP service number
MESSAGE_ID: message ID
no onu voip-mgc ONU-ID
message-id service
VOIP_SERVICE
Deletes the configured message ID.
i