Dasan V5808 - POTS UNI Configuration

User Manual UMN:CLI
V5808
731
Whenever an ONU is deployed with the IP-path managed VoIP service, the OLT should
assign the URL of a VoIP configuration file to communicate with the ONU VoIP client. The
provides an authentication method for ONUs to have access to the VoIP configuration
server.
To configure IP-path managed VoIP mode, use the following command.
Command
Mode
Description
ip-path uri URI
Traffic
VoIP-IP-
path
Configures a VoIP configuration server.
URI: IP-path URI
ip-path auth NAME [PASSWD]
Sets the user ID and password for IP-path managed
model to have access to VoIP configuration server.
NAME: user name used for authentication
PASSWD: password used for authentication
no ip-path { uri | auth }
Deletes the configured VoIP configuration server or
authentication information.
To specify the protocol on the current VoIP service, use the following command.
Command
Mode
Description
protocol { h248 | sip | mgcp}
Traffic
VoIP-IP-
path
Specifies the protocol on the current VoIP service.
sip: Session Initiation Protocol
h248, mgcp: Media Gateway Control protocol
(= MEGACO)
12.4.6.4 POTS UNI Configuration
To configure the user network interface, use the following command.
Command
Mode
Description
uni {pots | isdn} POTS_NUMBER
Traffic-VoIP
Configures the VoIP user network interface.
pots: POTS (Plain Old Telephone Service)
isdn: ISDN (Integrated Services Digital Network) (future
release)
POTS_NUMBER: POTS port number
no uni {pots | isdn}
POTS_NUMBER
Deletes the configuration of UNI.
If you specify UNI as the POTS by using uni pots command, you need to perform the
configuration for the interface in VoIP-UNI Configuration mode as follows:
When you use the uni pots command, you enter automatically VoIP-UNI Configuration
mode, where you can configure the specified POTS interface.
i