User Manual UMN:CLI
V5808
765
TABLE_TOKEN: the token used by the VoIP service to
process dial plans (This ASCII string is typically
delimited by ":".)
no dial-plan table TABLE_ID
Deletes the created dial plan table.
The dial plan created by dial-plan table command can be applied only if you configure
the dial plan format as H.248 by using dial-plan format h248 command.
In order to see the configured dial plan, use show voip-profile command.
12.7.3 OMCI-based MGC Configuration
MGCP (Media Gateway Control Protocol) is a signalling and call control protocol used
within VoIP systems that typically interoperate with the public switched telephone network
(PSTN).
If the ONUs are fully provisioned and managed from the using OMCI, you can configure
the MGC-related settings of these ONUs. The MGC entity defines the media gateway
controller configuration associated with an MG subscriber. It is conditionally required for
ONUs (ONTs) that support MGCP (H.248, Megaco) VoIP service.
You need to enter MGC mode to perform the MGC-related detail configuration. To enter
the MGC mode, use the following command.
To configure the IP address of primary and secondary MGC server that controls the
signalling messages, use the following command.
mgc {primary | secondary}
A.B.C.D
Configures the IP address of primary and secondary
MGC server.
no mgc {primary | secondary}
Deletes the configured IP address.
To configure the version of MGCP to be used, use the following command.
Configures the version of MGCP.
To define the message format, use the following command.
mgc msg-format {text-long |
text-short | binary}
Configures the message format. (default: text-long)
To Next Page
Loading...
Need help?
General