User Manual UMN:CLI
V5808
193
7.5.4.7 Applying and Modifying Policy
After configuring a policy using the above commands, apply it to the system with the
following command. If you do not apply the policy to the system, all specified
configurations from Policy Configuration mode will be lost.
To save and apply a policy, use the following command.
Applies a policy to the system.
To modify a policy, use the following command.
Modifies a policy, enter a policy name.
7.5.5 Displaying Rule
To show a rule profile configured by user, use the follwing command.
Shows a profile of policer.
Shows a profile of policy.
To dispaly a certain rule by its name or a specific rule of a certain type, use the following
command.
show { flow | class | policer |
policy } [NAME]
View
Enable
Global
Bridge
Shows the information relating to each rule, enter a
rule name.
show { flow | class | policer |
policy } detail [NAME]
show running-config { flow |
policer | policy }
Shows all configurations of each rule
7.5.6 Admin Rule
For the V5808, it is possible to block a specific service connection like telnet, FTP, ICMP,
etc with an admin rule function.
7.5.6.1 Creating Admin Flow for packet classification
To classify packets by a specific admin flow for the V5808, you need to open Admin-Flow
Configuration mode first. To open Admin-Flow Configuration mode, use the following
command.
To Next Page
Loading...