User Manual UMN:CLI
V5808
737
To display the list information of source MAC addresses for TDM pseudowire of ONU, use
the following command.
show onu tdm-pw source-
mac OLT-ID ONU-ID
Shows the list of source MAC addresses for
TDM pseudowire of the specified ONU.
show onu tdm-pw source-
mac ONU-ID
12.4.8 Management Mode
The OLT manages the ONU through an ONU management and control interface (OMCI)
path. An OMCI is a configuration transmission path defined in the GPON standard. If the
OLT manages the ONU through a non-OMCI path, this ONU’s UNI port is connected as a
Virtual Eth and is controlled by its web/TR-69/SNMP management system.
To specify the management mode of ONU’s UNI port, use the following command.
mgmt-mode uni { eth | pots | ces
| video } UNI_PORT { omci | non-
omci link virtual-eth NUMBER}
Specifies the management mode of ONU’s UNI port
using OMCI or non-OMCI path.
UNI_PORT: UNI port number (1-32)
no mgmt-mode uni { eth | pots |
ces | video } UNI_PORT
Deletes the specified UNI port’s management mode.
To display the configured management mode of ONU, use the following command.
show onu uni-mgmt OLT-ID
ONU-ID
Shows the management mode of ONU ID.
12.4.9 Configuring Rate-limit
To configure the rate limit profile, use the following command.
dot1-rate-limit {ucast | mcast |
bcast} profile PROF_NAME
Traffic-
TCONT /
Traffic-
Bridge
Sets the rate limit profile.
ucast: unicast
mcast: multicast
bcast: broadcast
PROF_NAME: profile name
dot1-rate-limit {ucast | mcast |
bcast} upstream PIR_VALUE
[SIR_VALUE]
Sets the upstream traffic bandwidth.
PIR_VALUE: PIR bandwidth range of 0 to 2147483584
SIR_VALUE: SIR bandwidth range of 0 to 2147483584
(in steps of 64Kbps)
no dot1-rate-limit [{ucast | mcast
Deletes the configured rate limit for downstream traffic.
To Next Page
Loading...