UMN:CLI User Manual
V5808
184
Creates a policy and opens Policy Configuration mode.
NAME: policy name.
After opening Policy Configuration mode, the prompt changes from SWITCH(config)# to
SWITCH(config-policy[NAME])#.
To delete configured policy or all policies, use the following command.
Deletes a policy, enter a policy name.
After opening Policy Configuration mode, a policy can be configured by user. The rule
priority and rule action(s) can be configured for each policy.
• The policy name must be unique. Its size is limited to 32 significant characters.
• The policy name cannot start with the alphabet “a” or “A”.
• The order in which the following configuration commands are entered is arbitrary.
• The configuration of a policy being configured can be changed as often as wanted
until the apply command is entered.
• Use the show policy-profile command to display the configuration entered up to
now.
If you already create the policy, you need to include specified flow or class and policer to
specify the rule action for the packets matching configured classifying patterns on flow or
class and policer.
To include specific flow or class and policer in policy, use the following command.
Includes specified flow in policy.
NAME:flow name
Includes specified class in policy.
NAME:class name
Includes specified policer in policy.
NAME:policer name
One policy is not able to include both flow and class at the same time. Either flow or class
can belong to one policy.
Only one policer can belong to one policy.
To remove flow or class, policer from the policy, use the following command.
Removes the flow from policy.
Removes the class from policy.
To Next Page