Dasan V5808 - Page 218

UMN:CLI User Manual
V5808
218
To remove the static MAC addresses manually registered by user from the MAC table,
use the following command.
Command
Mode
Description
no mac
Bridge
Deletes static MAC addresses.
no mac NAME
Deletes static MAC addresses, enter the bridge name.
no mac NAME PORT
Deletes static MAC addresses.
NAME: bridge name
no mac NAME PORT MACADDR
Deletes a specified static MAC address.
PORT: port number
MACADDR: MAC address
To display the MAC table in the switch, use the following command.
Command
Mode
Description
show mac [NAME]
Enable
Global
Bridge
Shows switch MAC address, selection by port number
(subscriber port only):
NAME: bridge name
PORT: port number
show mac NAME PORT
There are more than a thousand of MAC addresses in MAC table, so it is difficult to find
information you need at one sight. For that reason, the system shows a certain amount of
addresses displaying –more– on standby status. Press any key to search more. After you
find the information, you can go back to the system prompt without displaying the other
table by pressing <q>.
i