Dasan V5808 - Page 255

User Manual UMN:CLI
V5808
255
Command
Mode
Description
any: destination host
access-list {<100-199> | <2000-
2699>} {deny | permit} ip host
A.B.C.D host A.B.C.D
Specifies a deny or permit statement of the extended
ACL with a single source host and other variables.
host: single source/destination host
A.B.C.D: source/destination IP address of a host to
match
access-list {<100-199> | <2000-
2699>} {deny | permit} ip any
A.B.C.D WILDCARD-BITS
Specifies a deny or permit statement of the extended
ACL with any source host and other variables.
any: any source host
A.B.C.D: destination IP address to match
WILDCARD-BITS: bits for use of destination IP
address wildcard masking
access-list {<100-199> | <2000-
2699>} {deny | permit} ip any any
Specifies a deny or permit statement of the extended
ACL with any source host and other variables.
any: any source host
any: any destination host
access-list {<100-199> | <2000-
2699>} {deny | permit} ip any
host A.B.C.D
Specifies a deny or permit statement of the extended
ACL with any source host and other variables.
any: any source host
host: single destination host
A.B.C.D: destination IP address to match
access-list {<100-199> | <2000-
2699>} remark LINE
Adds comments for the extended ACL.
LINE: access list entry comments up to 100 characters
Add entries to the list by repeating the command for different IP addresses.
To delete an existing extended IP address-based access list entry, use the following
command.
Command
Mode
Description
no access-list {<100-199> |
<2000-2699>} {deny | permit} ip
A.B.C.D WILDCARD-BITS
A.B.C.D WILDCARD-BITS
Global
Deletes an entry of the extended ACL.
no access-list {<100-199> |
<2000-2699>} {deny | permit} ip
host A.B.C.D A.B.C.D
WILDCARD-BITS
no access-list {<100-199> |
<2000-2699>} {deny | permit} ip
host A.B.C.D any
Command
Mode
Description
no access-list {<100-199> |
<2000-2699>} {deny | permit} ip
Global
Deletes an entry of the extended ACL.
i