UMN:CLI User Manual
V5808
462
Static SSM mapping implemented for the V5808 has the following restriction, so you must
keep it in mind, before configuring static SSM mapping.
IGMP proxy and static SSM mapping cannot be enabled together. It means that SSM
mapping cannot be enabled when the system is already configured with upstream or
downstream interface with IGMP proxy feature.
Before configuring static SSM mapping, you should first globally enable SSM mapping. To
enable static SSM mapping, use the following command.
Enables SSM mapping for groups in a configured SSM
range.
no ip igmp ssm-map enable
Disables SSM mapping for groups.
To configure the switch to statically map groups that match specified ACL to source
address, use the following command.
ip igmp ssm-map static {<1-99> |
<1300-1999> | WORD} A.B.C.D
Enables a static SSM mapping for the group that
matches specified ACL and source address.
1-99: standard access list number
1300-1999: extended range of standard access list
WORD: IP named standard access list
A.B.C.D: source address to use for static map group
no ip igmp ssm-map static {<1-
99> | <1300-1999> | WORD}
A.B.C.D
Disables a static SSM mapping for the group that
matches specified ACL and source address.
To display the sources that SSM mapping uses for a particular group, use the following
command.
show ip igmp ssm-map [A.B.C.D]
Shows a static SSM mapping information
A.B.C.D: multicast group address
To Next Page