UMN:CLI User Manual
V5808
478
group is enough.
When the MLD snooping report suppression is enabled, a switch suppresses
membership reports from hosts other than the first one, allowing the switch to forward
only one membership report in response to a general query from a multicast router.
To enable the MLD snooping report suppression, use the following command.
ipv6 mld snooping report-
suppression
Enables the MLD snooping report suppression.
To disable the MLD snooping report suppression, use the following command.
no ipv6 mld snooping report-
suppression
Disables the MLD snooping report suppression.
10.2.3.5 Multicast Router Port Configuration
The multicast router port is the port which is directly connected to a multicast router. A
switch adds multicast router ports to the forwarding table to forward membership reports
only to those ports.
Static Multicast Router Port
You can statically configure Layer 2 port as the multicast router port which is directly
connected to a multicast router, allowing a static connection to a multicast router.
To specify a multicast router port, use the following command.
ipv6 mld snooping mrouter port
PORTS
Specifies a multicast router port.
PORTS: port number
To delete a specified multicast router port, use the following command.
no ipv6 mld snooping mrouter
port PORTS
Deletes a specified multicast router port.
Displaying Multicast Router Port
To display a current multicast router port for MLD snooping, use the following command.
Shows a current multicast router port for MLD snooping
To Next Page
Loading...