User Manual UMN:CLI
V5808
481
no ipv6 mld if flap discredit
Disables the MLD IF flap discredit.
To specify the discredit value in case of MLD IF flapping, use the following command.
ipv6 mld if flap discredit-unit <1-
50>
Specifies the discredit value for the IF flapping and
decreases the credit unit as much as a specified value.
(default: 5)
no ipv6 mld if flap discredit-unit
Deletes a configured discredit value.
To set the MLD IF flap credit regenerating rate, use the following command.
ipv6 mld if flap recover-interval
<0-3600>
Specifies the interval of recovering its credit as much
as a specified value. (default: 10 seconds)
ipv6 mld if flap recover-unit <1-
50>
Sets the regenerating value of the IF credit.
(default: 5)
no ipv6 mld if flap {recover-
interval | recover-unit}
Deletes a configured IF credit regenerating rate.
If you configure this rate as 0, the MLD IF credit is not regenerated!
To set the current MLD IF credit as the default (100), use the following command.
clear ipv6 mld if flap discredit
[NAME]
Restores the current credit to a default value (100).
NAME: MLD interface name
To Next Page
Loading...