Dasan V5808 - Page 671

User Manual UMN:CLI
V5808
671
onu auth radius-server host
A.B.C.D key WORD [auth-port
<0-65535>]
GPON
Specifies an IP address with key value and UDP port of
RADIUS server.
A.B.C.D: RADIUS server IP address
WORD: RADIUS authorization key value
0-65535: UDP port (default: 1812)
onu auth radius-username
{ serial-number | model-name}
Sends the ONU’s serial number-based or its model
name-based ID key value on the authentication
message to RADIUS server.
serial-number: uses GPON serial number of ONU
(default)
model-name: uses model name of ONU
onu auth radius-password
{ serial-number | model-name}
Sends the ONU’s serial number-based or its model
name-based password on the authentication message
to RADIUS server.
no onu auth radius-server host
A.B.C.D
Deletes the configured RADIUS server address.
To display the information of RADIUS server for ONU authentication, use the following
command.
Command
Mode
Description
show onu auth radius-server
GPON
Shows the information of RADIUS server for ONU
authentication.
You can see the status of ONU authentication via RADIUS server by the debug gpon
rauth command.
To enable/disable the ONU authentication for ONU profile, use the following command.
Command
Mode
Description
onu auth-control {enable |
disable }
GPON-OLT
Enables/disables the authentication control function for
the specified OLT port.
onu auth-control reauthenticate
Performs re-authentication processing for ONU.
To display the information of ONU authentication status and profile, use the following
command.
Command
Mode
Description
show onu auth-status [OLT-ID]
GPON
Shows the current authentication status of ONU.
show onu auth-status [ONU-ID]
GPON-OLT
i