Dasan V5808 - Page 797

User Manual UMN:CLI
V5808
797
SWITCH(config-traffic-pf[g-60a])# ip-host-config 1
SWITCH(config-traffic-pf[g-60a]-iphost[1])# ip address dhcp
SWITCH(config-traffic-pf[g-60a]-iphost[1])# vlan-operation us-oper overwrite
100 0
SWITCH(config-traffic-pf[g-60a]-iphost[1])# vlan-operation ds-oper remove
SWITCH(config-traffic-pf[g-60a]-iphost[1])# link voip-service 1
SWITCH(config-traffic-pf[g-60a]-iphost[1])# exit
SWITCH(config-traffic-pf[g-60a])# ip-host-config 2
SWITCH(config-traffic-pf[g-60a]-iphost[2])# ip address static
SWITCH(config-traffic-pf[g-60a]-iphost[2])# dns primary 168.123.0.1 secondary
168.123.0.2
SWITCH(config-traffic-pf[g-60a]-iphost[2])# vlan-operation us-oper overwrite
200 0
SWITCH(config-traffic-pf[g-60a]-iphost[2])# vlan-operation ds-oper remove
SWITCH(config-traffic-pf[g-60a]-iphost[2])# link tdm-service 1
SWITCH(config-traffic-pf[g-60a]-iphost[2])# exit
SWITCH(config-traffic-pf[g-60a])# voip-service 1
SWITCH(config-traffic-pf[g-60a]-voip[1])# manage-method omci
SWITCH(config-traffic-pf[g-60a]-voip[1])# voip-profile voip
SWITCH(config-traffic-pf[g-60a]-voip[1])# uni pots 1
SWITCH(config-traffic-pf[g-60a]-voip[1]-uni[1])# exit
SWITCH(config-traffic-pf[g-60a]-voip[1])# exit
SWITCH(config-traffic-pf[g-60a])# ces 1
SWITCH(config-traffic-pf[g-60a]-ces[1])# tdm-service 1 mode pw-ip
SWITCH(config-traffic-pf[g-60a]-ces[1]-svc[1]-pw-ip)# tdm-profile tdm
SWITCH(config-traffic-pf[g-60a]-ces[1]-svc[1]-pw-ip)# udp port 10 tos 20
SWITCH(config-traffic-pf[g-60a]-ces[1]-svc[1]-pw-ip)# exit
SWITCH(config-traffic-pf[g-60a]-ces[1])# exit
SWITCH(config-traffic-pf[g-60a])# apply
SWITCH(config-traffic-pf[g-60a])# exit
SWITCH(gpon)# onu-profile g-60a create
SWITCH(config-onu-profile[g-60a])# traffic-profile g-60a
SWITCH(config-onu-profile[g-60a])# pm-profile pm_ces
SWITCH(config-onu-profile[g-60a])# circuit-pack card-config c-ds1-e1 e1
SWITCH(config-onu-profile[g-60a])# apply
SWITCH(config-onu-profile[g-60a])# exit
SWITCH(gpon)#
Configuration Example 2
SWTICH(config)# gpon
SWTICH(gpon)# pm-profile PM_PROFILE create
SWTICH(config-pm-profile[PM_PROFILE])# pm gemport
SWTICH(config-pm-profile[PM_PROFILE])# pm aniport