Dasan V5808 - Page 809

User Manual UMN:CLI
V5808
809
Step 4 To perform the auto upgrade of OLT firmware when the version of two firmware is
different, regardless of the lastest firmware version, use the following command.
Command
Mode
Description
onu auto-upgrade version-
match all { enable | disable}
GPON-OLT
Enables/disables the ONU auto upgrade function
without verification of the firmware version.
onu auto-upgrade invalid-
version-match all { enable |
disable}
Enables/disables the ONU auto upgrade function
without verification of the firmware version format.
Step 5 Reflect the upgraded ONU firmware by restarting ONUs using the following command.
Command
Mode
Description
onu auto-upgrade reboot-time
{<0-23> | disable}
GPON
Specifies/deletes the time that upgrade-completed
ONUs restart.
0-23: restart time (unit: o’clock)
Step 6 Verify a progress of ONU auto upgrade using the following command.
Command
Mode
Description
show onu auto-upgrade info
GPON
GPON-OLT
Shows a progress of ONU auto upgrade.
OLT-ID: PON port number
show onu auto-upgrade status
GPON-OLT
Step 7 Verify the upgraded ONU firmware’s version using the following command.
Command
Mode
Description
show onu auto-upgrade
firmware [info]
GPON
Shows an ONU firmware version.
show onu auto-upgrade current-
fw
GPON-OLT
Shows a current ONU firmware.
14.4.3 Upgrade Time-out Configuration
It is possible to set the total upgrade time for ONU firmware update. If ONU firmware has
not been lownloaded from server during the specified time, it is regarded as a upgrade
failure.
To set the time out for ONU upgrade, use the following command.
Command
Mode
Description
onu upgrade download-timeout
[<60-600>]
GPON
Set the total time for ONU firmware download.
(defuat: 300 seconds)
onu upgrade commit-timeout
[<60-600>]
Set the total time for ONU upgrade commit.
(default: 300 seconds)