Dell S4810 - Page 904

Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following describes the show ip route all command in the following
example.
Field Description
(undefined) Identifies the type of route:
• C = connected
• S = static
• R = RIP
• B = BGP
• IN = internal BGP
• EX = external BGP
• LO = Locally Originated
• O = OSPF
• IA = OSPF inter area
• N1 = OSPF NSSA external type 1
• N2 = OSPF NSSA external type 2
• E1 = OSPF external type 1
• E2 = OSPF external type 2
• i = IS-IS
904
IPv4 Routing