Dell S4810 - Page 905

Field Description
• L1 = IS-IS level-1
• L2 = IS-IS level-2
• IA = IS-IS inter-area
• * = candidate default
• > = non-active route
• + = summary routes
Destination Identifies the route’s destination IP address
Gateway Identifies whether the route is directly connected and on
which interface the route is configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
Example
Dell#show ip route all
Codes:C- connected, S - static, R - RIP
B- BGP, IN - internal BGP, EX - external BGP, LO -
Locally Originated
O- OSPF, IA - OSPF inter area N1 - OSPF NSSA external
type 1
N2- OSPF NSSA external type 2, E1 - OSPF external type 1
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate
default
>- non-active route + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 3.0.0.0/8 via 100.10.10.10, So 2/8 120/1 00:07:12
via 101.10.10.10, So 2/9
100.10.10.0/24 Direct, So 2/8 0/0 00:08:54
> R 100.10.10.0/24 Direct, So 2/8 120/0 00:08:54
C 101.10.10.0/24 Direct, So 2/9 0/0 00:09:15
> R 101.10.10.0/24 Direct, So 2/9 120/0 00:09:15
Dell#
Example
(Summary)
Dell#show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
R1_E600i>show ip route static ?
| Pipe through a command
<cr>
R1_E600i>show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.10.91.9, Gi 1/2 1/0 3d2h
Dell>
IPv4 Routing
905