Dasan V5808 - Page 61

User Manual UMN:CLI
V5808
61
<0-15> {COMMAND | all}
Configuration mode in the level.
privilege gpon level
<0-15> {COMMAND | all}
Uses the specific command of GPON Configuration
mode in the level.
privilege gpon-olt level
<0-15> {COMMAND | all}
Uses the specific command of GPON-OLT
Configuration mode in the level.
The commands that are used in low level can be also used in the higher level. For
example, the command in level 0 can be used in from level 0 to level 14.
The commands should be input same as the displayed commands by show list.
Therefore, it is not possible to input the commands in the bracket separately.
SWITCH# show list
clear arp
clear arp IFNAME
clear coredump PID
clear ip arp inspection log
clear ip arp inspection statistics (vlan VLAN_NAME|)
clear ip bgp *
clear ip bgp * in
clear ip bgp * in prefix-filter
clear ip bgp * (unicast|multicast) in
clear ip bgp * (unicast|multicast) in prefix-filter
clear ip bgp * (unicast|multicast) out
clear ip bgp * (unicast|multicast) soft
clear ip bgp * (unicast|multicast) soft in
clear ip bgp * (unicast|multicast) soft out
clear ip bgp * out
(Omitted)
It is not possible to input clear ip bgp * unicast in. You should input like clear ip bgp *
{unicast | multicast} in.
The commands starting with the same character are applied by inputting only the starting
commands. For example, if you input show, all the commands starting with show are
applied.
To delete a configured security level, use the following command.
Command
Mode
Description
no privilege
Global
Deletes all configured security levels.
no privilege view level <0-15> {COMMAND | all}
Deletes a configured security level on
each mode.
no privilege enable level <0-15> {COMMAND |
all}
no privilege configure level <0-15> {COMMAND
| all}
no privilege interface level <0-15> {COMMAND |
all}
no privilege flow level <0-15> {COMMAND | all}
no privilege vrrp level <0-15> {COMMAND | all}