UMN:CLI User Manual
V5808
636
vid RANGE mapper MAPPER-ID
(This configuration is valid only when the GEM port
mapping mode is specified as ‘vid’ and the GEM port is
assigned through ONU profile configuration.)
ONU-ID: ONU ID or serial number
RANGE: VLAN ID range (This value should be unique
by each OLT port.)
MAPPER-ID: mapper number configured on Traffic
Profile
onu vlan-gem-mapping all vid
RANGE {multicast-gem |
broadcast-gem}
Maps the multicast or broadcast GEM port used by all
ONUs and the specified VLAN ID.
RANGE: VLAN ID range
no onu vlan-gem-mapping
[ONU-ID [vid RANGE] | all [vid
RANGE]]
Deletes the GEM port mapping configuration above.
The traffic is not transmitted while the GEM port mapping mode is being changed due to
user configuration.
To configure the downstream GEM port mode per flow, use the following command.
olt per-flow vid RANGE
mapping-method {mac | mac-vid
| vid}
Configures a downstream GEM port mapping based on
flow.
no olt per-flow [vid RANGE]
Deletes the configured downstream GEM port mapping
per flow.
If the V5808 is configured in the downstream GEM mapping mode per flow, you can
configure downstream QoS mapping mode based on MAC address / VLAN ID and the
mapping between queue and CoS value. To configure the downstream traffic control by
QoS mapping, use the following command.
olt ds-qos-mapping mode {mac |
vid }
Configures the downstream QoS mapping mode.
(This configuration is valid only when the downstream
GEM port mapping mode is specified as ‘flow’.)
mac: QoS mapping mode based on destination MAC
address
vid: QoS mapping mode based on VLAN ID
mac vid: QoS mapping mode based on MAC + VLAN
ID
olt ds-qos-mapping queue-
count {2 | 4 | 8} [cos-map <0-7>
<0-7> <0-7> <0-7> <0-7> <0-7>
<0-7> <0-7>]
Configures the queue count and priority value
according to CoS value.
2 | 4 | 8 : queue count
0-7 : queue number per each CoS value (CoS 0 to CoS
7)
no olt ds-qos-mapping mode
Deletes the QoS mapping configuration mode.
Deletes the queue count and CoS-Queue mapping
To Next Page
Loading...