User Manual UMN:CLI
V5808
637
The traffic is not transmitted while the GEM port mapping mode is being changed due to
user configuration.
To display the configuration of downstream traffic control, use the following command.
show olt ds-gem-mapping [OLT-
ID]
Shows the GEM port mapping mode configured on the
OLT.
show onu vlan-gem-mapping
[ONU-ID]
Shows VLAN ID mapped to GEM port of ONU.
show olt per-flow [VLANS]
Shows the downstream GEM Port mode per flow.
To display the configuration of downstream QoS mapping, use the following command.
show olt ds-qos-mapping [OLT-
ID]
Shows the queue count and CoS-Queue mapping table
of the GPON OLT.
show olt ds-qos-mapping mode
[OLT-ID]
Shows the QoS mapping mode configured on the OLT.
Shows the queue count and CoS-Queue mapping table
status.
show olt ds-qos-mapping mode
Shows the downstream QoS mapping mode.
To configure the traffic control by selecting the method of upstream flow mapping, use the
following command.
olt us-flow-mapping per-mapper
Selects the upstream flow mapping based on mapper.
This method learns MAC addresses of incoming traffic
from the several GEM port IDs associated with different
ONUs to a MAPPER-defined GEM port ID.
olt us-flow-mapping per-gem
Selects the upstream flow mapping based on GEM
port. This method learns MAC addresses of incoming
traffic from the GEM port IDs associated with different
ONUs to each GEM port ID, respectively.
To display the configured upstream flow mapping, use the following command.
To Next Page
Loading...