Dasan V5808 - Page 638

UMN:CLI User Manual
V5808
638
show olt us-flow-mapping [OLT-
ID]
Enable
Global
GPON
Shows the upstream flow mapping status.
show olt us-flow-mapping
GPON-OLT
12.1.14 Multicast/Broadcast GEM Port Separation
All the downstream multicast and broadcast flows from the V5808 are transmitted through
a single GEM port ID. The multicast and broadcast flows need to be separated from each
other to properly forward all broadcast/multicast traffic for multiple ONTs.
To configure a multicast GEM port ID, use the following command.
Command
Mode
Description
olt multicast-gem <4094-4095>
GPON
Adds a specific GEM port ID to the multicast stream.
4094-4095: multicast GEM port ID
show olt multicast-gem
GPON
GPON-OLT
Shows the specified GEM port ID for multicast stream.
To enable/disable the interworking with IGMP snooping table, use the following command.
Command
Mode
Description
olt interwork igmp-snooping
{enable | disable}
GPON
Enables/disables the interworking with IGMP snooping
table.
To add a static MAC address into the MAC table, use the following command.
Command
Mode
Description
olt static-mac MACADDR {mcast
| bcast} [vid <1-4094>]
GPON-OLT
Adds a static MAC address for multicast/broadcast
stream.
olt static-mac start MACADDR
end MACADDR {mcast | bcast}
[vid <1-4094>]
Adds a static range of MAC addresses for
multicast/broadcast stream.
no olt static-mac MACADDR
{mcast | bcast} [vid <1-4094>]
Deletes the configured static MAC address.
no olt static-mac start
MACADDR end MACADDR
{mcast | bcast} [vid <1-4094>]
Deletes the configured static MAC address range.
To display the configured static MAC address table, use the following command.
Command
Mode
Description
show olt static-mac OLT-ID
Enable
Global
GPON
GPON-OLT
Shows the static MAC table.