EasyManua.ls Logo

Dasan V5808 - Page 693

Dasan V5808
814 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Manual UMN:CLI
V5808
693
dns primary 168.126.63.1
link voip-service 1
extended-vlan-tagging-operation V903
ip-host-config 2
ip address static
extended-vlan-tagging-operation V200
voip-service 1
manage-method omci
voip-profile SIP
uni pots 1
uni pots 2
apply
!
Create a traffic profile (TRAFFIC).
If you want to set "Bridge", then you should use omci.
Otherwise, if you want to set "NAT" or "PPPoE", then you should use non-omci.
Basically, non-omci configures an interface as "NAT". For the PPPoE, PPPoE
enabling on web interface is required additionally.
Associate the created DBA profiles (BE - for Internet & multicast service, VOIP - for
VoIP service) to T-CONT.
Associate the created extended VLAN tagging operation profile to each Ethernet
port (extended-vlan-tagging-operation V200 - for Internet service (eth 1 in
this config), extended-vlan-tagging-operation V501 - for multicast service
(eth 2 to eth 4 in this config)).
Associate the created multicast profile (V501) to the Ethernet ports for multicast
service (eth 2 to eth 4 in this config).
Configure ip-host-config 1.
The ip-host-config 1 is a host only for VoIP.
- Configure IP address assignment (static in this config).
- Associate a VoIP service (voip-service 1) to this configuration (ip-host-
config 1).
- Associate the created extended VLAN tagging operation profile (extended-vlan-
tagging-operation V903) to this configuration (ip-host-config 1).
Configure ip-host-config 2.
The ip-host-config 2 is a host only for non-omci-configured interfaces.
- Configure IP address assignment (static in this config).
- Associate the created extended VLAN tagging operation profile (extended-vlan-
tagging-operation V200) to this configuration (ip-host-config 2).
In case of ip address static, it is required to configure DNS. Otherwise, it is set
to the DASAN-specified value, by default, which may cause to limit any service.
Create a VoIP service (voip-service 1) to be associated to IP host
configuration for VoIP (ip-host-config 1). And then configure the corresponding
settings. Here, associate the created VoIP profile (SIP).

Table of Contents