Dasan V5808 - Page 696

UMN:CLI User Manual
V5808
696
associated with this generic status portal.
The generic status portal ME uses two attributes which are status and config to convey
status and configuration from a non-OMCI managed domain to the OMCI. Each of these
attributes uses an XML document to present this information.
Whenever the information in this table changes, and after a soak interval, the ONU issues
an AVC to the OLT. The rate at which AVCs are issued is controlled by the avc-report
attribute.
To configure GSP, follow these steps.
Step 1 You need to open ONU Profile Configuration mode to configure an ONU profile.
To create an ONU profile, use the following command.
Command
Mode
Description
onu-profile NAME create
GPON
Creates an ONU profile.
NAME: ONU profile name
Step 2 To enable GSP function, use the following command.
Command
Mode
Description
gsp {disable | enable}
ONU-
Profile
Enables generic status portal. (default:
disable)
gsp avc-report enable
{10min | sec}
Configures the rate of AVC report.
10min: ONU issues one AVC report to the
OLT per 10 minutes
sec: ONU issues one AVC report to the OLT
per seconds
enable: Whenever the information changes,
ONU generates AVC report. (Not
recommended.)
disable: Not generating the report to the OLT
gsp avc-report disable
Disables the configured avc-report.
Step 3 You need to apply a created ONU profile to connected ONU, open GPON-OLT
Configuration mode where you want to apply the profile.
Command
Mode
Description
gpon-olt PORT
GPON
Opens GPON-OLT Configuration mode.
PORT: OLT’s port number
Step 4 To apply the ONU profile to connected ONUs use the following command.
Command
Mode
Description
onu-profile ONU-IDs NAME
GPON-OLT
Applies an ONU profile to specified ONUs.
ONU-IDs: ONU ID (1 to 128) or ONU serial
number