Dasan V5808 - Page 697

User Manual UMN:CLI
V5808
697
NAME: ONU profile name
Step 5 To update GSP information, use the following command.
Command
Mode
Description
onu gsp update {status |
config} ONU_ID
GPON-
OLT
Updates GSP.
ONU_ID: ONU ID (1 to128) or ONU serial
number
In case of enable status, whenever the information in the table changes, GSP will be
automatically updated according to Step 2 avc-report rate settings.
Step 6 To display a current configured GSP information, use the following command.
Command
Mode
Description
show onu gsp {config | status}
ONU_ID
GPON-OLT
Shows the configured GSP information.
config: configuration document table
status: status document table
ONU_ID: ONU ID (1 to128) or ONU serial
number
TAG_NAME: tag name
show onu gsp {status | config}
ONU_ID tag TAG_NAME
show onu gsp {status | config}
ONU_ID tag-list
The following is an example of configuring a GSP.
...
SWITCH(gpon)# onu-profile H660GW create
SWITCH(config-onu-profile[H660GW])# gsp enable
SWITCH(config-onu-profile[H660GW])# apply
!
...
SWITCH(config-onu-profile[H660GW])# exit
SWITCH(gpon)# gpon-olt 1/1
SWITCH(config-gpon-olt[1/1])# show onu model-name 11
-------------------------------
OLT | ONU | Model Name
-------------------------------
1/1 | 11 | H660GW
SWITCH(config-gpon-olt[1/1])# onu-profile 11 H660GW
SWITCH(config-gpon-olt[1/1])# onu gsp update config 11
SWITCH(config-gpon-olt[1/1])# show onu gsp config 11
<?xml version="1.0"?>
<gspResponse type="config">
<ONTSystemInfo>
<SoftImage type="0" Active="1">1.42-0001</SoftImage>
<SoftImage type="1" Active="0">1.42-0001</SoftImage>
i