Cisco Catalyst 4500 Series Software Configuration Guide

38-28
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 38 Configuring IP Multicast
Monitoring and Maintaining IP Multicast Routing
Displaying PIM Statistics
The following is sample output from the show ip pim interface command:
Switch# show ip pim interface
Address Interface Mode Neighbor Query DR
Count Interval
198.92.37.6 Ethernet0 Dense 2 30 198.92.37.33
198.92.36.129 Ethernet1 Dense 2 30 198.92.36.131
10.1.37.2 Tunnel0 Dense 1 30 0.0.0.0
The following is sample output from the show ip pim interface command with a count:
Switch# show ip pim interface count
Address Interface FS Mpackets In/Out
171.69.121.35 Ethernet0 * 548305239/13744856
171.69.121.35 Serial0.33 * 8256/67052912
198.92.12.73 Serial0.1719 * 219444/862191
The following is sample output from the show ip pim interface command with a count when IP
multicast is enabled. The example lists the PIM interfaces that are fast-switched and process-switched,
and the packet counts for these. The H is added to interfaces where IP multicast is enabled.
Switch# show ip pim interface count
States: FS - Fast Switched, H - Hardware Switched
Address Interface FS Mpackets In/Out
192.1.10.2 Vlan10 * H 40886/0
192.1.11.2 Vlan11 * H 0/40554
192.1.12.2 Vlan12 * H 0/40554
192.1.23.2 Vlan23 * 0/0
192.1.24.2 Vlan24 * 0/0
Clearing Tables and Databases
You can remove all contents of a particular cache, table, or database. Clearing a cache, table, or database
might be necessary when the contents of the particular structure have become, or are suspected to be,
invalid.
To clear IP multicast caches, tables, and databases, enter one of these commands:
Command Purpose
Switch(config)# show ip pim interface
[type number] [df | count]
[rp-address]
Displays information about the elected designated
forward (DF) for each RP of an interface, along with
the unicast routing metric associated with the DF.
Switch(config)# show ip pim rp
[mapping | metric] [rp-address]
Displays information about configured RPs, learned by
using Auto-RP or BSR, along with their unicast routing
metric.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E