Cisco Catalyst 4500 Series Software Configuration Guide

62-47
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 62 Configuring Network Security with ACLs
Configuring Object Group ACLs
Creating an IPv6 Service Object Group
To create an IPv6 service object group , perform this task:
Step 4
Repeat the steps until you have specified all objects on
which you want to base your object group.
Example:
Switch(config-v6network-group)# 2002::1/64
—
Step 5
{end } | { exit }
Example:
Switch(config-network-group)# end
To exit the configuration mode, enter the end command.
To exit the IPv6-address object-group configuration mode,
enter the exit command.
Command or Action Purpose
Command or Action Purpose
Step 1
configure terminal
Example:
Switch# configure terminal
Enters global configuration mode.
Step 2
object-group v6-service object-group-name
Example:
Switch(config)# object-group v6-service mySG
Defines object group name and enters the service
object-group configuration mode.
Step 3
{0-255 | ahp | description descripton-text | esp | exit |
group-object | hbh | icmp | ipv6 | no | pcp | sctp | tcp
| tcp-udp | udp}
Example:
Switch(config-v6service-group)# description
example of service object group
Switch(config-v6service-group)# esp
(Optional) Configures a member of the group and specifies
a description of the object group.
For the object group, you can configure a network address
plus mask or a host (identified by host name or IPv6
address)
Step 4
Repeat the steps until you have specified all objects on
which you want to base your object group.
Example:
Switch(config-v6service-group)# ahp
—
Step 5
{end } | { exit }
Example:
Switch(config-v6service-group)# end
To exit the configuration mode, enter the end command.
To exit the IPv6-address object-group configuration mode,
enter the exit command.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E