Cisco Catalyst 4500 Series - Auto Identity

CHAPTER
54-1
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
54
Auto Identity
The Auto Identity feature provides a set of built-in policies at global configuration and interface
configuration modes. This feature is available only in Class-Based Policy Language (CPL) control
policy-equivalent new-style mode. To convert all the relevant authentication commands to their CPL
control policy-equivalents, use the authentication convert-to new-style command.
This module describes the feature and consists of these sections:
• Information About Auto Identity, page 54-1
• How to Configure Auto Identity, page 54-5
• Configuration Examples for Auto Identity, page 54-6
• Verifying Auto Identity, page 54-7
Note For complete syntax and usage information for the switch commands used in this chapter, see the
Cisco IOS Command Reference Guides for the Catalyst 4500 Series Switch.
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference , you can locate it in
the Cisco IOS Master Command List, All Releases.
Information About Auto Identity
• Auto Identity Overview, page 54-2
• Auto Identity Global Template, page 54-2
• Auto Identity Interface Templates, page 54-3
• Auto Identity Built-in Policies, page 54-4
• Auto Identity Class Map Templates, page 54-4
• Auto Identity Parameter Maps, page 54-5
• Auto Identity Service Templates, page 54-5