37-12
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 37 Configuring Unicast Reverse Path Forwarding
Unicast RPF Configuration Example: Inbound and Outbound Filters
The show access-lists command displays the number of matches found for a specific entry in a specific
access list.
Switch> show access-lists
Extended IP access list 197
deny ip 192.168.201.0 0.0.0.63 any log-input (1 match)
permit ip 192.168.201.64 0.0.0.63 any log-input (1 match)
deny ip 192.168.201.128 0.0.0.63 any log-input
permit ip 192.168.201.192 0.0.0.63 any log-input
Unicast RPF Configuration Example: Inbound and Outbound
Filters
The following example uses a very simple single-homed ISP to demonstrate the concepts of ingress and
egress filters used in conjunction with Unicast RPF. The example illustrates an ISP-allocated classless
interdomain routing (CIDR) block 209.165.202.128/28 that has both inbound and outbound filters on the
upstream interface. Be aware that ISPs are usually not single-homed. Provisions for asymmetrical flows
(when outbound traffic goes out one link and returns by using a different link) must be designed into the
filters on the border switches of the ISP.
ip cef distributed
!
interface Serial 5/0/0
description Connection to Upstream ISP
ip address 209.165.200.225 255.255.255.252
no ip redirects
no ip directed-broadcast
no ip proxy-arp
ip verify unicast reverse-path rx allow-default
ip access-group 111 in
ip access-group 110 out
!
access-list 110 permit ip 209.165.202.128 0.0.0.31 any
access-list 110 deny ip any any log
access-list 111 deny ip host 0.0.0.0 any log
access-list 111 deny ip 127.0.0.0 0.255.255.255 any log
access-list 111 deny ip 10.0.0.0 0.255.255.255 any log
access-list 111 deny ip 172.16.0.0 0.15.255.255 any log
access-list 111 deny ip 192.168.0.0 0.0.255.255 any log
access-list 111 deny ip 209.165.202.128 0.0.0.31 any log
access-list 111 permit ip any any
To Next Page
Loading...
