77-18
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 77 Configuring Call Home
Call Home Default Settings
Total Ratelimit
-dropped 0 0 0
Config 0 0 0
Diagnostic 0 0 0
Environment 0 0 0
Inventory 0 0 0
SysLog 0 0 0
Test 0 0 0
Request 0 0 0
Send-CLI 0 0 0
Last call-home message sent time: n/a
Call Home Default Settings
Table 77-2 lists the default Call Home settings.
Alert Group Trigger Events and Commands
Call Home trigger events are grouped into alert groups, with each alert group assigned CLI commands
to execute when an event occurs. The CLI command output is included in the transmitted message.
Table 77-3 lists the trigger events included in each alert group, including the severity level of each event
and the executed CLI commands for the alert group.
Table 77-2 Default Call Home Settings
Parameters Default
Call Home feature status Disabled
User-defined profile status Active
Predefined Cisco TAC profile status Inactive
Transport method E-mail
Message format type XML
Destination message size for a message sent in long text, short text, or XML format 3,145,728
Alert group status Enabled
Call Home message severity threshold 1 (normal)
Message rate limit for messages per minute 20
Table 77-3 Call Home Alert Groups, Events, and Actions
Alert Group
Call Home
Trigger Event Syslog Event Severity Description and CLI Commands Executed
Syslog Event logged to syslog. (Only sent to TAC if syslog
level 0, 1, or 2)
CLI commands executed:
show logging
show inventory
SYSLOG LOG_EMERG 7 System is unusable.
To Next Page
Loading...
Need help?
General
