Cisco Catalyst 4500 Series - Monitoring Programmability

6-23
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 6 Programmability
Monitoring Programmability
Monitoring Programmability
Use these commands in the privileged EXEC mode, to display the Programmability settings you have
configured:
Table 6-1 Monitoring Programmability
Show Command Purpose
debug remotemanagement dmi Displays the list of applications for which you can debug information. You can choose
from the following list of applications
• ciaauthd—Debug CIA Authorizaition Daemon
• ciam—Debug CiaManager
• confd—Debug Confd
• monit—Debug Monit
• nes—Debug Network Element Synchronizer
• odm—Debug Operational Data Manager
• snmp—Debug SNMP Notification Processor
• syncfd—Debug SyncFromDaemon
show onep session all Displays OneP session information. To verify if NETCONF and RESTCONF
interfaces are configured correctly, ensure that these three sessions are listed:
NetworkElementSynchronizer, SyncFromDaemon and CiaAuthDaemon. The
following is sample output for this command:
Switch #
show onep session all
ID Username State ReconnectTimer ConnectTime ApplicationName
8145 Connected 0 Thu Jul 28 06:07:05.304
com.cisco.NetworkElementSynchronizer
3234 Connected 0 Thu Jul 28 06:07:06.504 com.cisco.SyncFromDaemon
7249 Connected 0 Thu Jul 28 06:07:07.343 com.cisco.CiaAuthDaemon
show remotemanagement dmi Displays the list of applications for which you can display log and status information.
You can choose from the following list of applications:
• ciaauthd—Show CIA Authorization Daemon
• ciam—Show CiaManager
• confd—Show Confd
• genet—Show Mapping Framework
• log—Show all DMI logs
• monit—Show Monit
• nes—Show Network Element Synchronizer
• odm—Show Operational Data Manager
• snmp—Show SNMP Notification Processor
• status—Show status for all DMI applications
• syncfd—Show SyncFromDaemon
show virtual-service [global] Displays available memory, disk space, and CPU allocated for applications.