Cisco Catalyst 4500 Series Software Configuration Guide

32-15
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 32 Configuring LLDP, LLDP-MED, and Location Service
Cisco IOS Carries Ethernet Features in Cisco IOS XE 3.1.0SG
Cisco IOS Carries Ethernet Features in Cisco IOS XE 3.1.0SG
This section provides a list of High Availability software features that are supported in Cisco IOS XE
3.1.0SG. Links to the feature documentation are included.
Feature guides may contain information about more than one feature. To find information about a
specific feature within a feature guide, see the Feature Information table at the end of the guide.
Feature guides document features that are supported on many different software releases and platforms.
Your Cisco software release or platform may not support all the features documented in a feature guide.
See the Feature Information table at the end of the feature guide for information about which features in
that guide are supported in your software release. Use Cisco Feature Navigator to find information about
platform support and Cisco software image support. To access Cisco Feature Navigator, go to
http://www.cisco.com/go/cfn. An account on Cisco.com is not required.
ANSI TIA-1057 LLDP-MED Support and IEEE 802.1ab LLDP (Link Layer Discovery Protocol)
http://www.cisco.com/en/US/docs/ios/cether/configuration/guide/ce_lldp-med.html
show lldp entry entry-name
Displays information about a specific neighbor.
You can enter an asterisk (*) to display all neighbors, or you can enter the name
of the neighbor about which you want information.
show lldp errors
Displays LLDP computational errors and overflows.
show lldp interface [interface-id]
Displays information about interfaces where LLDP is enabled.
You can limit the display to the interface about which you want information.
show lldp neighbors [interface-id]
[detail]
Displays information about neighbors, including device type, interface type and
number, holdtime settings, capabilities, and port ID.
You can limit the display to neighbors of a specific interface or expand the display
to provide more detailed information.
show lldp traffic
Displays LLDP counters, including the number of packets sent and received,
number of packets discarded, and number of unrecognized TLVs.
show location
Displays the location information for an endpoint.
show nmsp
Displays the NMSP information.
show power inline interface [detail]
Displays detailed information on the PoE status for the interface
show power inline module mod
[detail]
Displays detailed information on the PoE consumption for the specified module.
Command Description

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E