EasyManuals Logo

Cisco Catalyst 4500 Series Software Configuration Guide

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #467 background imageLoading...
Page #467 background image
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS
Chapter 9 Configuring Interfaces
Configuring Optional Interface Features
Note This feature is only available when a DOM capable transceiver is present and configured for monitoring.
The frequency at which the sensor information is refreshed depends on default values configured in the
transceiver SEEPROM (Serial Electrically Erasable Programmable Read Only Memory).
Note For details on transceiver module compatibility, refer to this URL:
http://www.cisco.com/en/US/products/hw/modules/ps5455/products_device_support_tables_list.html
Configuring Optional Interface Features
The following sections describe optional procedures:
• Configuring Ethernet Interface Speed and Duplex Mode, page 9-27
• Configuring Flow Control, page 9-32
• Configuring Jumbo Frame Support, page 9-34
• Interacting with Baby Giants, page 9-37
• Configuring the Port Debounce Timer, page 9-38
• Configuring Auto-MDIX on a Port, page 9-39
Configuring Ethernet Interface Speed and Duplex Mode
Topics include:
• Speed and Duplex Mode Configuration Guidelines, page 9-27
• Setting the Interface Speed, page 9-28
• Setting the Interface Duplex Mode, page 9-30
• Displaying the Interface Speed and Duplex Mode Configuration, page 9-30
• Adding a Description for an Interface, page 9-32
Speed and Duplex Mode Configuration Guidelines
Note You do not configure the client device for autonegotiation. Instead, you configure the switch with the
speed, or range of speeds, that you want to autonegotiate.
You can configure the interface speed and duplex mode parameters to auto and allow the Catalyst 4500 series switch to
negotiate the interface speed and duplex mode between interfaces. If you decide to configure the interface speed and duplex
commands manually, consider the following:
• If you enter the no speed command, the switch automatically configures both interface speed and duplex to auto.
• When you set the interface speed to 1000 (Mbps) or auto 1000, the duplex mode is full duplex. You cannot change the
duplex mode.
• If the interface speed is set to 10 or 100, the duplex mode is set to half duplex by default unless you explicitly configure it.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals