Cisco Catalyst 4500 Series - Debug Output Filtering Per VRF

To Next Page

To Previous Page

83-23

Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex

Chapter 83 Configuring Easy Virtual Network

Troubleshooting EVN Configuration

10.1.8.13 (red/13,red/13) 0 msec

3 10.1.2.11 (red/13,blue/10) 1 msec 0 msec 0 msec

4 * * *

Debug Output Filtering Per VRF

Using EVN, you can filter debug output per VRF by using the debug condition vrf command. The

following is sample output from the debug condition vrf command:

Device# debug condition vrf red

Condition 1 set

CEF filter table debugging is on

D1#

*Aug 19 23:06:38.178: vrfmgr(0) Debug: Condition 1, vrf red triggered, count 1

CISCO-VRF-MIB

EVN provides a CISCO-VRF-MIB for VRF discovery and management.

Other manuals for Cisco Catalyst 4500 Series