EasyManuals Logo

Cisco Catalyst 4500 Series Software Configuration Guide

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #323 background imageLoading...
Page #323 background image
6-11
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 6 Programmability
Configuring Programmability Components
Providing Privilege Access to Use NETCONF and RESTCONF
This task is mandatory for both zero touch provisioning, and the standard configuration method.
To start working with NETCONF and RESTCONF APIs you must be a user with privilege level 15. To
provide this, perform the following task:
Step 4
service set vty
Example:
Switch(config-onep)# service set vty
Enables the VTY service set. The VTY service enables the
OneP application to communicate with a network element via a
virtual terminal.
Step 5
end
Example:
Switch# end
Exits the onep configuration mode and enters the privileged
EXEC mode.
Command or Action Purpose
Command or Action Purpose
Step 1
enable
Example:
Switch# enable
Enables the privileged EXEC mode. Enter your password if
prompted.
Step 2
configure terminal
Example:
Switch# configure terminal
Enters the global configuration mode.
Step 3
username name privilege level password
password
Example:
Switch (config)# username example-name
privilege 15 password example_password
Establishes a user name-based authentication system.
Configure the following keywords:
• privilege level—Sets the privilege level for the user. For
the programmability feature, it must be 15.
• password password—Sets a password to access the CLI
view.
Step 4
end
Example:
Switch# end
Exits global configuration mode and enters privileged EXEC
mode.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals