Cisco Catalyst 4500 Series Software Configuration Guide

81-10
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 81 Configuring WCCP Version 2 Services
WCCP Configuration Examples
Example: Performing a General WCCP Configuration
The following example shows a general WCCP configuration session. VLAN 20 is for the client
interface. VLAN 50 is for the content engine interface.
Switch# configure terminal
Switch(config)# ip wccp web-cache group-address 224.1.1.100 password alaska1
Switch(config)# interface vlan 20
Switch(config-if)# ip wccp web-cache redirect in
Switch(config)# interface vlan 50
Switch(config-if)# ip wccp web cache group-listen
The following example shows a general IPv6 WCCP configuration where GigabitEthernet 0/1/0 is the
client interface and GigabitEthernet 0/2/0 is the content engine interface:
Switch# configure terminal
Switch(config)# ipv6 wccp interface GigabitEthernet 0/1/0
Switch(config)# ipv6 wccp check services all
Switch(config)# interface GigabitEthernet 0/1/0
witch(config-if)# ipv6 wccp redirect in
Switch(config)# interface GigabitEthernet 0/2/0
Example: Running a Web Cache Service
The following example shows a web cache service configuration session with ingress redirection, for
IPv4:
Switch# configure terminal
Switch(config)# ip wccp web-cache
Switch(config)# interface vlan 20
Switch(config-if)# ip wccp web-cache redirect in
Switch# copy running-config startup-config
Switch# show ip interface vlan 20 | include WCCP Redirect
WCCP Redirect inbound is enabled
WCCP Redirect exclude is disabled
The following example shows a web-cache service configuration session with ingress redirection, for an
IPv4 VRF interface:
Switch#configure terminal
Switch(config)#ip wccp vrf test web-cache
Switch(config)#interface vlan 10
Switch(config-if)#vrf forwarding test
Switch(config-if)#ip wccp vrf test web-cache redirect in
Switch# copy running-config startup-config
Example: Running a Reverse Proxy Service
Note The WCCP reverse proxy service is not supported for IPv6 traffic.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E