3-34
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 3 Configuring the Switch for the First Time
Resetting a Switch to Factory Default Settings
Resetting a Switch to Factory Default Settings
Manufacturing and repair centers can use the erase /all non-default command to do the following:
• Clear the nonvolatile configurations and states of the local supervisor engine (NVRAM and flashes).
• Set the factory default parameters on the Catalyst 4500 series switch before it is ready to ship to a
customer.
For example, entering this command can generate the following output:
Switch# erase /all non-default
Erase and format operation will destroy all data in non-volatile storage. Continue?
[confirm]
Formatting bootflash: ...
Format of bootflash complete
Erasing nvram:
Erasing cat4000_flash:
Clearing crashinfo:data
Clearing the last power failure timestamp
Clearing all ROMMON variables
Setting default ROMMON variables:
ConfigReg=0x2101
PS1=rommon ! >
EnableAutoConfig=1
Setting vtp mode to transparent
%WARNING! Please reboot the system for the changes to take effect
Switch#
00:01:48: %SYS-7-NV_BLOCK_INIT: Initialized the geometry of nvram
Switch#
If the Catalyst 4500 series switch is accessible to a TFTP server, you can copy an image to the bootflash
memory with the TFTP command:
Switch# copy tftp://192.20.3.123/tftpboot/abc/cat4500-entservices-mz.bin bootflash:
When the copying is completed, you can reboot the just-copied Catalyst 4500 series switch image to the
image stored in the bootflash memory with the reload command:
Switch# reload
System configuration has been modified. Save? [yes/no]: no
Proceed with reload? [confirm]
00:06:17: %SYS-5-RELOAD: Reload requested by console. Reload Reason: Reload Command.
To see details about the default parameters set by the erase /all non-default command, see the usage
guidelines for the erase command in the Catalyst 4500 Series Switch Cisco IOS Command Reference.
To Next Page
Loading...
