EasyManuals Logo

Cisco Catalyst 4500 Series Software Configuration Guide

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #899 background imageLoading...
Page #899 background image
CHAPTER
32-1
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
32
Configuring LLDP, LLDP-MED, and Location
Service
This chapter describes how to configure the Link Layer Discovery Protocol (LLDP), LLDP Media
Endpoint Discovery (LLDP-MED), and Location Service on the Catalyst 4500 series switch.
This chapter consists of these sections:
• About LLDP, LLDP-MED, and Location Service, page 32-1
• Configuring LLDP and LLDP-MED, and Location Service, page 32-4
• Monitoring and Maintaining LLDP, LLDP-MED, and Location Service, page 32-14
• Cisco IOS Carries Ethernet Features in Cisco IOS XE 3.1.0SG, page 32-15
Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
IOS Configuration Fundamentals Command Reference and the Cisco IOS Command Reference Guides
for the Catalyst 4500 Series Switch.
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference , you can locate it in
the Cisco IOS Master Command List, All Releases.
About LLDP, LLDP-MED, and Location Service
This section describes this information:
• LLDP, page 32-1
• LLDP-MED, page 32-2
• Location Service, page 32-3
LLDP
The Cisco Discovery Protocol (CDP) is a device discovery protocol that runs over Layer 2 (the data link
layer) on all Cisco-manufactured devices (routers, bridges, access servers, and switches). CDP allows
network management applications to automatically discover and learn about other Cisco devices
connected to the network.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals