CHAPTER
68-1
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
68
Configuring Wireshark
Beginning with Cisco IOS Release XE 3.3.0SG in the IP Base and Enterprise Services feature sets, the
Catalyst 4500 series switch supports Wireshark.
Note Wireshark is only supported on Supervisor Engine 8-E, Supervisor Engine 7l-E, Supervisor Engine 7-E,
Catalyst 4500X-16, and Catalyst 4500X-32.
Note Wireshark is supported on VSS and the functionality is the same as a standalone switch except for a few
configuration differences as detailed in the “Configuring Wireshark on VSS” section on page 68-14.
• Finding Feature Information, page 68-1
• Prerequisites for Wireshark, page 68-2
• Guidelines for Wireshark, page 68-2
• Restrictions for Wireshark, page 68-4
• Information about Wireshark, page 68-5
• How to Configure Wireshark, page 68-11
• Monitoring Wireshark, page 68-14
• Configuration Examples for Wireshark, page 68-15
• Usage Examples for Wireshark, page 68-18
• VSS Specific Examples, page 68-31
Note For complete syntax and usage information for the switch commands used in this chapter, see the
Cisco IOS Command Reference Guides for the Catalyst 4500 Series Switch.
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference , you can locate it in
the Cisco IOS Master Command List, All Releases.
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
To Next Page
Loading...
