EasyManuals Logo

Cisco Catalyst 4500 Series Software Configuration Guide

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #221 background imageLoading...
Page #221 background image
4-43
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 4 Administering the Switch
Managing the MAC Address Table
Feature Incompatibility
The following features are incompatible with disabling MAC address learning and do not work properly
when the feature is enabled:
• 802.1X—The 802.1X class of features does not work when learning is disabled because some of
these features require source miss, which is ignored.
• Port security— Port security VLANs requires learning to be enabled. To secure MAC addresses,
packets must first arrive at the CPU. However, if you disable learning on a VLAN, SA suppression
ensures that packets do not operate this way.
• Unicast flood blocking— When unicast flood blocking is enabled on a port, it is removed from the
VLAN flood set. If learning is disabled on the same VLAN, the host connected to that port do not
receive traffic.
• DHCP snooping—To send the packet out the correct port once a DHCP request has been resolved,
DHCP snooping must learn the MAC address. If you disable learning, the switch do not know on
which port to exit the packet; the two features are incompatible.
• Broadcast storm control— This feature does not interact with the learning disable feature.
• Flooding of packets in a VLAN domain in which learning is disabled through PVL.
Partial Feature Incompatibility
Although the following features are partially incompatible with disabling MAC address learning, they
still retain a large portion of their functionality:
• FlexLink—FlexLink functions and upstream convergence is not impacted. However, downstream
fast convergence uses a MAC table to send dummy multicast packets for each learned MAC address
upstream to expedite downstream convergence. This situation does not happen if you enabled
learning disable. FlexLink downstream convergence occurs naturally, but it is slower if learning is
enabled on that VLAN.
• PVLAN—To observe correct behavior, you must disable learning on the primary VLAN and all
secondary VLANs associated with the primary VLAN.
Note To avoid confusion, configure PVLAN similarly on both the primary and secondary VLANs in
the PVLAN space.
• Spanning Tree (STP)—Except for the UplinkFast feature, per-VLAN spanning tree functionality is
not impacted. To achieve faster downstream convergence, UplinkFast forwards dummy multicast
packets using learned MAC addresses. This action is not possible unless MAC learning is enabled.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals